Ginny and I were not big fans of your factory entrance door handle. With our set up, the interior shade would partially block the interior grip. Additionally, there was very little room to grab the handle to close the door. Researching this a bit I ran across this tip and thought I would try it. Simply put, I added a standard 3″ black cabinet handle to the inside grip. You will need to take apart the handle to get this done. This is a very simple procedure, you will be removing four screws. Mark and drill two 1/8 inch or similar size to your handle hardware holes in the grip. Screw the handle on. Replace the latch and you are in.
